How to:

 Floatie

1. Thread one bead onto your necklace wire so that it sits in the center.

2. Thread one crimp each end of your wire so that it sits on either side of your bead.

3. Squash the crimps using flat nosed pliers so that they hold your bead securely onto the wire.
4. Measure out each side, from the crimps, to the desired distance (usually around 2.5cm) and squash a crimp at these points.

5. Place a bead and another crimp onto each side of your wire and secure your crimps.

6. Repeat these steps until you have the desired length of your necklace.

7. To attach clasp: thread one crimp, then one end of your clasp onto each side.

8. Thread the ends of your necklace back through your crimps and secure (squash) crimp.  Trim of your excess wire.

N.B. Do not bend the wire

 

BACK TO WEBSITE